Hot Tips For Installing Heated Grips

Heated grips are great for extending your riding season and staying comfortable when the temperature drops. When it comes to choosing heated grips you essentially have two options: cheapo panels that go beneath your existing grips, or complete assemblies with integrated heating elements. While they tend to be more expensive and a little bulky, integrated kits usually work better and come with higher-quality controls and wiring.

Before you can install your new grips you’ll need to remove the old ones. Getting your OEM bar-ends off can be a bear, so use a T-handle for leverage and hold the bar-end with a pair of channel locks and a rag to keep the weight from rotating. Use a razor blade to slice off your old grips (no going back now!) and then scrape off any glue residue and wipe the bar and throttle tube clean with a rag doused in isopropyl alcohol or carb cleaner.

Some OEM throttle tubes have ridges and/or a flange molded into them that you’ll need to knock down before you can slide on the heated grip. A sharp utility knife and some 120-grit sandpaper will do the trick, but if you have access to a bench grinder or a benchtop belt sander, that will yield the quickest and cleanest results.

Now that you’ve got your bars prepped, it’s time to slide on those grips. Most integrated heated grips are too rigid to be blown on with my favorite installation accessory, compressed air. Your best bet is to douse the inside of the grip and your bar with a quick-evaporating fluid like–you guessed it–isopropyl alcohol, and then push the grip on with a twisting motion. Some grips are so robust that they need to be coaxed into place with a rubber mallet.

Depending on the kit, you may have a dial or control switches that need to be mounted in a convenient place. Regardless of how easy or visually appealing it might be to place said switches on the right side of your cockpit, don’t do it. You want those controls as close to your left grip as possible so they’re easy to use.

When it comes to running the grip wiring back to your battery, it’s best to route it along a frame rail away from pinch points and moving parts, which often means removing some bodywork or perhaps the tank. Secure the wires with zip ties and make sure you leave enough slack at the right grip and headstock to accommodate full throttle and full steering sweep. If your bike’s bodywork is a nightmare to remove, you can use a fish tape to push the wires from the headstock back to the battery.

The final step is to get the grips powered up, and with most kits it’s as easy as slipping the supplied fused ring terminals under the battery bolts. As always, you’ll want to disconnect the negative (black wire) terminal first and affix it last to avoid an unpleasant and potentially dangerous short. Most accessories come with fused power hookups, but if not it’s important to wire in a fuse of the appropriate amperage (typically 5 to 7.5A) to protect against shorts. And you should review your owner’s manual to make sure you’re not overburdening your bike’s electrical system.

The ideal wiring situation for heated grips and any other electrical accessories is a relay or switched power-distribution box, but we’ll save that topic for another article. In the meantime, get your grips hooked up, test them to see how toasty they get and then keep an eye out for a decent day to go for a ride.
Previous post Next post

0 comments