2008 Mitsubishi Eclipse Key Fob Remote Programming Instructions

Here are the programming instructions for a 2008 Mitsubishi Eclipse Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at https://heart-horse.com/ You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family.

This procedure does NOT program the key portion of the Key-Remote Combo. It only programs the remote portion.

1. Locate the Data Port under drivers side dashboard usually located to the right of steering column.

2. Insert keys in ignition and leave in the OFF position.

3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.

4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.

5. Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.

6. Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.

7. Disconnect the programming wire and remove the keys from the ignition.

Previous post Next post

0 comments