2008 Jeep Commander Key Fob Remote Programming Instructions

Here are the programming instructions for a 2008 Jeep Commander Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at https://heart-horse.com/ You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family.

Programming Instructions:

Please Note: You must have two working keys (Keys that start your car) to perform this task.

1. Cut the new key to match existing keys
.
2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON position for at least three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key.

3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON position within 15 seconds. After 10 seconds, a chime will sound. In addition, the vehicle security light will being to flash. Turn the ignition switch to the LOCK position and remove the second key.

4. Insert a blank key into the ignition switch. Turn the ignition switch to the ON position within 60 seconds. After 10 seconds a single chime will sound. In addition, the vehicle security light will stop flashing. To indicate that programming is complete, the vehicle Security light will turn on again for three seconds and then turn off.

5. The new key is now programmed. The Remote Keyless Entry Transmitter will also be programmed during this process.

6. Repeat this procedure to program up to eight keys.

Previous post Next post

0 comments